• Horsepower & Torque: 700 Horsepower / 640 FT LBS
• Compression Ratio: 9.5:1
• Aluminum Heads
• Hydraulic Roller Cam
• Nodular Iron Crankshaft
• Forged Pistons

Block:

• BluePrint Engines High Strength Cast Iron 6.2L Block
• Increased Deck Thickness and Strength Webbing
• Extended Cylinder Skirt
• Priority Main Oiling
• 4.070" Bore
• 6-Bolt Main
• 1-Piece Rear Main Seal
• Improved Water Jacket Design

Rotating Assembly:

• Forged Crankshaft
• 3.622" Stroke
• 6.125" Connecting Rods w/ 150,000 PSI Bolts
• Forged Pistons
• Internally Balanced Front and Rear

Cylinder Heads:

• BluePrint Aluminum Cylinder Heads - PS8015
• 70cc Chamber
• 2.165" Intake / 1.600" Exhaust Valves
• 259cc Intake / 102cc Exhaust Runners

Cam Specs:

• Cam Type: Hydraulic Roller Cam
• .612 Intake / .585 Exhaust Lift
• 225 Intake / 238 Exhaust Duration
• @.050-113 Degree Lobe Separation

Also Includes:

• Holley Terminator X Max - Gen IV Complete ECU/Harness EFI System
• Magnuson TVS2650 Super Charger
• Coil Packs
• Valve Covers
• Oil Pan
• All Sensors Required for Engine to Run
• Drive by Wire Throttle Body
• Throttle Pedal
• Timing Cover
• Spark Plugs & Wires
• Harmonic Balancer
• Front Accessory Drive with Power Steering Pump, Water Pump, Alternator, and Air Compressor

Notes:

• Not for use in pollution-controlled vehicles.
• BluePrint Engines Recommends Air Intake Kit BPPLS01013 to ensure correct MAF calculations and Dyno calibration are maintained with the above ECU / tuning.