Overview:
Blueprints BP327CTFKV GM Small Block Compatible performance crate engines are dyno tested at our factory with a Holley Sniper II EFI System. This produces 350 horsepower and 350 ft. lbs. torque. This engine comes as a deluxe dressed engine that comes with: Premium Vintage Valve Covers, Premium Vintage Air Cleaner as well as the Fuel Pump and Feed lines. Makes this engine a great drop in for performance. Comes with a Polished Pulley Kit.
Description:
- Horsepower & Torque: 350 Horsepower / 350 FT. LBS. Torque
- Compression Ratio: 9.4:1
- Aluminum Heads
- Hydraulic Roller Cam
- Forged Crank
- Hypereutectic Pistons
Block:
- BluePrint Engines High Strength Cast Iron Block
- 4-Bolt Main
- 4.000" Bore
- 1-Piece Rear Main Seal
- Mech Fuel Pump Provision: Yes
- Passenger Side Dipstick
- Drilled and Tapped for Clutch Linkage
Rotating Assembly:
- New BluePrint Forged Crankshaft
- 3.250" Stroke
- Forged 5.700" Connecting Rods w/ 150,000 PSI Bolts
- Hypereutectic Pistons
- Internally Balanced Front - Externally Balanced Rear
Cylinder Heads:
- BluePrint Aluminum Cylinder Heads - H8002K
- 64cc Chamber
- 2.02" Intake / 1.60" Exhaust Valves
- 195cc Intake / 75cc Exhaust Runners
Cam Specs:
- Cam Type: Roller
- .495 Intake / .502 Exhaust Lift
- 220 Intake / 224 Exhaust Duration
- @ .050-114 Degree Lobe Separation
Ignition Timing:
- 32-34 Degrees Total at 3500 RPM
Also Includes:
- Holley Sniper 2 EFI System
- Premium Vintage Valve Covers
- Premium Vintage Air Cleaner
- 6.75-inch Harmonic Balancer
- Spark Plugs
- Under Header Spark Plug Wires (Perfect for Rams Horn exhaust manifolds)
- Fuel Pump and Feed Line
- Rear Sump Oil Pan
- Timing Cover
- Aluminum Intake Manifold
- Pro Billet Distributor
- Polished Front Accessory Drive with Water Pump, A/C Compressor, Alternator, and Power Steering Pump
- Thermostat and Thermostat Housing
Recommended Break in Oil: BPP710 (Click Here)
Recommended Service Oil: BPP10W30 (Click Here)
Recommended Oil Filter: BPP51061 (Click Here)
Notes:
- Not for use in pollution-controlled vehicles.
- The front accessory drive on this engine fits many vehicles, however it is the customer responsibility to accurately measure and confirm fitment. Note this is a low-profile design, but things such as power steering hoses, alternator wiring, and additional fittings/fabrication may be required on some vehicles.